Adding points and paths

You can connect two points to become a line. This line represents a path on the map.

1. Go to URL: YUOR_URL/admin_interface/

2. Choose Manage floor plan

3. Choose the floor you want to edit.

4. Click the Draw Point button on the menu, and then click on the map where the point will be located.

5. Click the Draw Edge button, and then choose two points to connect.

6. Click SAVE DATA button on the menu.

7. Done

Removing points and paths

1. Go to URL: YUOR_URL/admin_interface/

2. Choose Manage floor plan

3. Choose the floor you want to edit.

4. Click Edge Picking button and then choose the path you want to delete. The selected path should become red

5. Click Remove Edge button. The path should be removed. You need to repeat this action twice to delete a single visible path as a path is bidirectional in the system.

6. Removing points is similar.

7. If you want to remove a point, make sure it is not connected by any edge. To remove a point, first click Point Picking button then choose a point then click Remove Point button

8. Click SAVE DATA button on the menu.

9. Done